When was the last time the roof of your building was inspected? If it’s been awhile, the roof could have problems lurking that require immediate attention. Some roof problems cause obvious signs such as for example leaks, while others produce subtle signs that are only detectable on the surface. In either case, leaving the problems unaddressed can cost you thousands once you finally repair them. If the roof on your building has the problems listed below, a company that focuses on commercial roofing should repair them quickly:

Buckled Panels

Roof panels buckle because of weather damage and poor installation. Regardless of Soft wash roof cleaning near me , the buckling allows wind to blow underneath the panels, making them loose. As the problem worsens, the panels begin to fall off, often coming off in large sections whenever a storm hits. Buckled panels are probably one of the most commonly fixed problems by companies that perform roof repair.

Expended Screw Holes

Expanded screw holes are another problem for panel roofs. Over time, wind and fluctuating temperatures cause the screw holes in panels to widen around the screws that contain the panels set up. This creates an area where water can leak within the panels and soak the roof deck. After the deck becomes saturated, the thing is costly to fix.

Blistering

Improper heating procedures and dry lapping cause hot bituminous roof systems to blister. Although small blisters seldom pose a problem, large ones can rupture and invite water to seep under the bitumen. Once the blisters form, hot weather typically makes them worse. Because of the humid subtropical climate in some regions of the country, commercial roofing frequently experiences blistering.

Ponding Water

Blocked drains and improper sloping can cause water to assemble in small ponds on a roof. Repairing a blocked drain is simple, but fixing a sloping problem is more technical. Often, installing a taper insulation system to establish a new slope is the better solution. Through the rainy season, resolving ponding water is probably the most common forms of roof repair.

Loose Flashing

Flashing prevents water from seeping in the crevice where the roof abuts to protrusions such as for example chimneys and vents. As time passes, most flashing must be resealed. If it’s not, leaks could cause serious damage the deck and building interior. Most flashing problems are corrected during the course of scheduled maintenance.

Missing Mortar

Chimneys and high parts of brick walls that have sections of missing mortar could cause leaks. These leaks are often mistaken for leaks in the roof membrane, but a thorough inspection by way of a company that focuses on commercial roofing will reveal the true problem. Most sections of missing mortar can be repaired with basic tuck pointing procedures.

Conclusion

The problems above are some of the most common reasons for roof repair. If they are corrected early, most problems are cheap to fix, but not addressing them until they cause serious problems may necessitate roof replacement. Having a scheduled maintenance agreement with a roofing company is the greatest way to ensure problems are detected early.

Leave a Reply

Your email address will not be published. Required fields are marked *